Solid Cast Brass or Solid Cast Aluminum
Address Plaques.
A Refined Look for Your Home!

Measure the distance between the center of the keyhole slots on the back of the plaque.
Select location on the wall and, using the measurement from step 1, mark the locations for the keyhole slots.
Important- after marking the wall, verify your markings with the distance between the slots on the plaque.
After verifying alignment and spacing, you are ready to drill the pilot holes for mounting.
Follow instruction "A" for wood siding. Follow instruction "B" for brick or masonry.

Instruction A (wood siding): Drill pilot hole with 3/32" drill bit. Screw mounting screws into wall, leaving approximately 1/4" gap between the wall surface and screw heads.

Instruction B (brick/masonry): Drill 3/16" hole 1" deep and insert plastic screw sleeve (provided). Insert screws leaving approximately 1/4" gap between the wall surface and screw heads. Note: for applications where the brick mortar is significantly recessed, use longer screws.

Mount plaque on wall.

Customer Service	Privacy	Returns	About	Guarantees	Testimonials	Commercial Division
©2006 Seattle Luxe, Inc. Kent WA 98042 800-325-6262

�

Solid Cast Brass or Solid Cast Aluminum Address Plaques. A Refined Look for Your Home!

Solid Cast Brass or Solid Cast Aluminum
Address Plaques.
A Refined Look for Your Home!